Pulastic Classic 110

Pulastic Classic 110

Seamless point-elastic floor covering for multi-purpose gymnasia and sports halls

Product Description

Pulastic Classic 110 Eco is a multi-purpose sports floor providing very good comfort and safety for training and competition combined with excellent resistance to mechanical loads.

Pulastic Classic 110 Eco is approved according the EN 14904 standard in category P1.

Pulastic Classic 110 Eco is approved by the F.I.V.B. (International Volleyball Federation), F.I.B.A. (International Basketball Federation) and I.H.F. (International Handball Federation).

Pulastic Classic 110 Eco is manufactured under ISO 9001 for quality control and ISO 14001 for environmental care.

Uses

  • Indoor
  • Training and competition of all common international sports activities and badminton
  • Physical education
  • Cultural events, exams, exhibitions and a variety of non-athletic activities typical for multi-purpose halls.

Characteristics / Advantages

  • Very good resiliency for comfort and injury prevention
  • Seamless, non-porous and smooth surface for easy maintenance, repair and resurface procedures
  • Sustainability through high content of recycled and renewable raw materials in combination with lasting performance through outstanding mechanical strength and wear resistance
  • Water based finish for very low odor during installation and maximum indoor clean air protection during use
  • Outstanding mechanical strength and wear resistance for minimum life cycle cost and maximum usability (return on investment)
  • Outstanding ball bounce
  • Wide colour selection with outstanding colour fastness
  • No glare for clear visibility of the durable line marking
  • Excellent contact noise reduction (acoustic isolation)
  • Outstanding thermal insulation

Product Data

Color : 16 Classic colours and 16 Design colours as per manufacturers colour brochure.

Technical Data / System

Nominal thickness 11 mm
Shock absorption 28 % EN 14808
Vertical Deformation 1,4 mm EN 14809
Linear Friction (dry) 98 EN 13036-4
Linear Friction (damp) 0,3 Leroux
Ball Bounce 98 % EN 12235
Gloss 3 % EN 2813
Resistance to rolling load > 1500 N EN 1569
Resistance to impact > 800 gr @ 10°C EN 1517
> 1200 gr @ 17°C EN 1517
Resistance to indentation 0,35 mm @ 5 min EN 1516
0,15 mm @ 24 hrs EN 1516
Resistance to wear 150 mg EN ISO 2813
Flammability Bfl-S1 EN 13501-1

Technical Data / Components

V.O.C. content - adhesive Solvent free
V.O.C. content - finish 0,01 gr/lit (EU) 2004/42/EG
45 gr/lit (US) ASTM D 3960
Resin composition Free of solvents and heavy metals
Elongation at break - structure 200 % DIN 53455
Tensile strength - structure 10 N/mm² DIN 53455
Tear strength - structure 25 N/mm DIN 53515

Installation

Installation shall be carried out corresponding to manufacturers installation

instructions, by a manufacturer trained installer.

Conditions / Limitations

The subfloor shall correspond to manufacturers document “requirements prior to the installation of a Pulastic sports floor”.

Cleaning / Maintenance

The instructions for pre-treatment and cleaning corresponding to manufacturers document “Initial use and general maintenance tips for your Pulastic sports floor” shall be carried out to promote hygiene and assure that the floor retains its matt appearance and proper grip/sliding characteristics. This improves safety and enhances sport performance.

Value Base

All technical data stated in this System Data Sheet are based on laboratory tests. Actual measured data may vary due to circumstances beyond our control.